Construction

Sealing Options

Sealing Type selection depends on the application, industry, and customer preference.

Overview

The Right Seal for Every Application

All Seals are Installed in the Air Gap Between the Gear Case and Rotor Case and can accommodate External Flushing Plans Requirements when Required.

Sealing Selection and design is crucial in pump performance and reliability. A light duty seal will not last as long as a conventional spring loaded mechanical seal.

Seal Type Selection Guide

Single Mechanical Seal Flushless Cartridge Type Front Pullout Design

Flushless Single Mechanical Seal Spring Loaded Cartridge Type Front Pullout Design with Shaft Protection Sleeve. Rotating Faces are Tungsten Carbide vs Silicon Carbide. All Stainless Steel Construction.

Single Mechanical Seal Flushed Cartridge Type Front Pullout Design

Flushed Single Mechanical Seal Spring Loaded Cartridge Type Front Pullout Design with Shaft Protection Sleeve. Rotating Faces are Tungsten Carbide vs Silicon Carbide. All Stainless Steel Construction

Double Mechanical Seals Cartridge Type Front Pullout Design

Double Mechanical Seal Spring Loaded Cartridge Type Front Pullout Design with Shaft Protection Sleeve and flush and buffer connections per API 682/676. Rotating Faces are Tungsten Carbide vs Silicon Carbide. All Stainless Steel Construction or as specified by client.

Double or Triple Lip Seal Cartridge Type Front Pullout Design

Flushless Double Lip Seal Design Spring Loaded Cartridge Type Front Pullout Design with hardened Shaft Protection Sleeve. (Does Not Comply with API 682)

Floating Ring Loaded for Light Duty low pressure Applications.

Oil Bath Floating O Ring Design in lieu of the Conventional Metal with Ductile Iron Rotating and Stationary Faces. (Does Not Comply with API 682)

Conventional Packing

Packing with Packing Flush, Axially Split Stuffing Box for In Place Packing Replacement, with Hardened Shaft Sleeve and Gland Follower.

01

SINGLE MECHANICAL SEAL WITH SHAFT PROTECTION SLEEVE FLUSH-LESS OR FLUSH TYPE

02

DOUBLE MECHANICAL SEAL WITH SHAFT PROTECTION SLEEVE WITH BUFFER FLUID CONNECTIONS AND FLUSH CONNECTION

03

DOUBLE OR TRIPLE LIP SEAL DESIGN

04

FLOATING RING TYPE FOR LIGHT DUTY – LOW PRESSURE APPLICATIONS

05

CONVENTIONAL FLUSHED PACKING

Conventional flushed packing seal arrangement cross-section diagram